The Electra 200NB power bollard range of enclosures are designed for use with Clipsal 56 series switch gear & are supplied with a galvanised pre-punched mounting plate to take 2,4,6 & 8 standard mounting enclosures. The backing plate measures 150mm Wide x 450mm Height – If you require additional space, we have the Electra two door model (ELE202B) which will double the capacity.

 

On installations where water is required inside behind the bottom door, we recommend specifying a 1/4 turn tap be used.

 

All power / water accessories are not included & must be installed / supplied by your electrical contractor / end user.

 

Electrical installation must be carried out by a licensed electrical contractor, to comply with SAA wiring rules (AS3000) & any additional requirements of statutory authorities in your state or territory.

 

Most commonly installed in outdoor parks, civic plaza’s, outdoor area’s at sporting complexes, golf courses, farmers markets and local council markets in general. The basic need to have power, water or both distributed from the bollard is met . Power and water distribution can be secured both when in use and not in use. The doors on the bollard have a small gap on the underside so users can unlock the door, plug in for power for example and lock the door. There is a rubber seal which helps prevent water ingress. This is an important security and safety requirement.

 

If the Electra enclosure bollard is being installed in close proximity (2km) to sea water, we recommend supplying these in a hot dip galvanised finish instead of powdercoating finish. (please specify this when ordering – Code: GAL200)

If you would like a painted finish over the hot dip galvanising, we recommend a whip blast, wet spray primer and final wet spray colour.

Vandal door design is also available for parks and public spaces.

 

 

For additional drawings and information, see the downloads & resources tab above.

 

  • Description

    The Electra 200NB power bollard range of enclosures are designed for use with Clipsal 56 series switch gear & are supplied with a galvanised pre-punched mounting plate to take 2,4,6 & 8 standard mounting enclosures. The backing plate measures 150mm Wide x 450mm Height – If you require additional space, we have the Electra two door model (ELE202B) which will double the capacity.

     

    On installations where water is required inside behind the bottom door, we recommend specifying a 1/4 turn tap be used.

     

    All power / water accessories are not included & must be installed / supplied by your electrical contractor / end user.

     

    Electrical installation must be carried out by a licensed electrical contractor, to comply with SAA wiring rules (AS3000) & any additional requirements of statutory authorities in your state or territory.

     

    Most commonly installed in outdoor parks, civic plaza’s, outdoor area’s at sporting complexes, golf courses, farmers markets and local council markets in general. The basic need to have power, water or both distributed from the bollard is met . Power and water distribution can be secured both when in use and not in use. The doors on the bollard have a small gap on the underside so users can unlock the door, plug in for power for example and lock the door. There is a rubber seal which helps prevent water ingress. This is an important security and safety requirement.

     

    If the Electra enclosure bollard is being installed in close proximity (2km) to sea water, we recommend supplying these in a hot dip galvanised finish instead of powdercoating finish. (please specify this when ordering – Code: GAL200)

    If you would like a painted finish over the hot dip galvanising, we recommend a whip blast, wet spray primer and final wet spray colour.

    Vandal door design is also available for parks and public spaces.

     

     

    For additional drawings and information, see the downloads & resources tab above.

     

  • Downloads & Resources